1)hot compression热压缩
1.Research on the constitutive equation of Al_2O_(3sf)/LY12 composite under hot compression deformation;Al_2O_(3sf)/LY12复合材料热压缩变形流变本构方程研究
2.The cellular automata(CA) model with dynamic recrystallization(DRX) is proposed and used to investigate the flow behavior and microstructure evolution during hot compression of AZ91 alloy.采用基于动态再结晶的元胞自动机模型模拟分析AZ91镁合金热压缩过程中的流变行为及组织演变。
3.To establish the prediction model of flow stress of BT20 titanium alloy(Ti6Al2Zr1Mo1V),the flow stress curves have been obtained by hot compression experiments and the algorithm of BP neural network has been improved,based on which the flow stress of BT20 alloy has been precisely predicted.为建立BT20钛合金(Ti6Al2Zr1MolV)的流动应力预测模型,通过热压缩试验获得其流动应力曲线,并对BP神经网络的算法进行改进,实现BT20钛合金的流动应力的准确预测。
英文短句/例句
1.RESEARCH ON ISOTHERMAL COMPRESSION AND HOT EXTRUSION TECHNOLOGY SPRAY FORMED 60Si-40Al ALLOY喷射成形60Si-40Al合金热压缩与热挤压工艺研究
2.Study of Thermal Squeezed Effect of Magnons in the Ferromagnet;铁磁晶体中磁振子热压缩效应的研究
3.Study on the Hot Compression Deformation Behavior in AZ91D Magnesium Alloy;AZ91D镁合金热压缩变形行为研究
4.The Research of 7075Al/SiCp Composites During Hot Compression Deformtion;7075Al/SiCp复合材料热压缩变形的研究
5.Research on Metal Hydride Compressor Which Output Hydrogen with Pressure up to 35MPa35MPa金属氢化物氢气热压缩机研究
6.Flow Stress Behavior of 7056 Aluminum Alloy During Hot Compression Deformation at Elevated Temperature7056铝合金高温热压缩流变应力行为
7.Calibration of axisymmetric hot compression test results and verification for Cr9Mo steelCr9Mo钢热压缩试验结果的标定及验证
8.Microstructure in as-cast AZ61 magnesium alloy during hot compression deformation铸态AZ61镁合金热压缩变形组织变化
9.Compression deformation behavior of AZ91D magnesium alloy at elevated temperatureAZ91D镁合金的热压缩变形行为
10.Hot compression deformation behavior of Cu-2.32Ni-0.57Si-0.05P alloyCu-2.32Ni-0.57Si-0.05P合金热压缩变形研究
11.Hot Compression and Microstructural Evolution of Ti43Al5Nb0.03Y AlloyTi43Al5Nb0.03Y合金高温热压缩行为及其组织演变
12.Flow stress behavior of 2026 aluminium alloy under hot compression deformation2026铝合金热压缩变形流变应力行为
13.Flow Behavior of 2026 Aluminum Alloy During Hot Compression Deformation2026铝合金热压缩变形流变行为研究
14.thermodynamics of compressible fluid flo可压缩流体流动热力学
15.Experiment on Two-stage Compression Air-source Heat Pump Water Heater两级压缩空气源热泵热水器实验研究
16.Gases cannot be quickly compressed without generating heat.气体迅速压缩就一定会产生热量。
17.Plastics--Compression moulding test specimens of thermoplastic materialsGB/T9352-1988热塑性塑料压缩试样的制备
18.testing method for compressive strength of insulating fire bricks绝热耐火砖耐压缩强度试验方法
相关短句/例句
thermal vapor compression热压缩
1.Study on Low Temperature Multi-effect Distillation with Thermal Vapor Compression;带热压缩的低温多效蒸发海水淡化系统研究
2.The performance variation under different operating condition was calculated for the steam ejector used in thermal vapor compression desalination system coupling with the subroutine of thermo-dynamics of water and steam.结合水蒸气物性程序,对热压缩海水淡化系统中的蒸汽喷射压缩器的变工况性能进行了计算,分析了工作蒸汽压力、引射压力、混合蒸汽压力的变化对引射系数的影响。
3.Computational model of steam ejector for thermal vapor compression desalination system is set up by application of modified thermal dynamic method.采用改进热力学法,建立了应用于热压缩蒸馏海水淡化系统的蒸汽喷射器的计算模型。
3)thermomechanical processes热/力压缩
1.The elevated temperature plastic deformation was studied by thermomechanical processes for three kinds of Mg-RE alloys in different temperature and different strain rate.采用热/力压缩模拟实验研究了3种镁-稀土合金在不同变形条件下高温塑性变形行为。
4)adiabatic compression绝热压缩
1.Optimization of adiabatic compression in dispersion decreasing fiber using distributed Raman amplification;基于拉曼放大对色散渐减光纤的绝热压缩效果的优化
2.Then the distribution of the temperature in the flow field is calculated on the basis of considering the adiabatic compression.以不可压缩理想流体对称碰撞模型对金属粉末爆炸烧结中由微爆炸焊接引起的颗粒界面附近沉积的能量进行了分析,在考虑热传导效应的基础上推导出了焊接流场中二维形式的能量方程并用有限差分法对其进行了求解,在考虑冲击绝热压缩贡献的基础上计算出了焊接流场中的温度分布。
3.This paper describes the reason of adiabatic compression produced and its harm to the dissolved acetylene production.介绍了绝热压缩产生的过程对溶解乙炔生产的安全影响以及有关预防措施。
5)squeezed thermal state热压缩态
6)thermally compressible热可压缩
延伸阅读
热压缩模拟试验机热压缩模拟试验机 热压缩模拟试验机
