1)steam turbine rotor汽轮机转子
1.Analysis and control of low cycle fatigue damage of N125 steam turbine rotor in Huangpu Thermal Power Plant;黄埔电厂N125汽轮机转子低周疲劳损伤分析与控制
2.The influence made by the central hole of steam turbine rotor to temperature and stress distribution of rotor;汽轮机转子中心孔对转子温度和应力分布的影响
3.Recurrence algorithm of thermal stress monitoring on line for steam turbine rotors;汽轮机转子热应力在线监测的递推算法
英文短句/例句
1.Electrochemistry Study for Hot Embrittle of 30Cr2MoV Turbine Rotor Steel;30Cr2MoV汽轮机转子钢热脆化的电化学研究
2.The Study of Life Wastage and Life Forecast of Steam Turbine Rotor;大型汽轮机转子寿命损耗和预测研究
3.Numerical Computation of Fatigue Life in Large Steam Turbine Rotor;大型汽轮机转子疲劳寿命的数值模拟
4.The Study on EPR Behavior of 30Cr2MoV Rotor Steel;30Cr2MoV汽轮机转子钢的EPR行为研究
5.Online Monitor System about Thermal Status of Large Steam Turbine Rotor;大型汽轮机转子热状态在线监测系统
6.Strength and Reliability Analysis of Connecting Components of a Turbine Rotor汽轮机转子连接件强度及可靠性分析
7.TEMPERATURE MONITORING SYSTEM FOR STEAM TURBINE ROTOR BASED ON LABVIEW基于LabVIEW的汽轮机转子温度监测系统
8.Discussion on Maintenance Technology of Center Hole of 300 MW Steam Turbine Rotor300MW汽轮机转子中心孔检修工艺探讨
9.An Experimental Study on PPT Behaviors of 30Cr2MoV Steel30Cr2MoV汽轮机转子钢的PPT行为研究
10.Vibration Analysis of Turbine Rotor System under Alford and Oil-film Forces汽流和油膜作用下的汽轮机转子振动特性研究
11.Steam Turbine Rotor Crack Analysis and Processing of 150 Plant 50MW Unit;一五零电厂50MW机组汽轮机转子裂纹分析及处理
12.The Vibration Analysis of a Steam Turbine Because of Oil Enter the Rotor Center Bore一台汽轮机转子中心孔进油的振动原因分析
13.Research on Nondestructive Test Technique for Detecting Temper Embrittlement of Steam Turbine Rotor;汽轮机转子热脆化的非破坏性检测法研究
14.Experimental Studies on the Shaft Material Properties of Supercritical Turbine Set;超临界汽轮机转子材料特性的实验研究
15.Study on Simulation and Intelligent CAPP of Forging Process for Steam Turbine Rotor;大型汽轮机转子锻造工艺模拟与智能CAPP研究
16.Study of Creep Life of Steam Turbine Rotor Steel 30Cr1Mo1V Based on Electrical Resistance Method;基于电阻法的30Cr1Mo1V汽轮机转子钢蠕变寿命研究
17.Study of DSP Based Steam-Turbine Rotor Vibration Condition Monitoring System;基于DSP的汽轮机转子振动监测系统研究
18.The shaft of the turbine is coupled to the rotor of the generator.汽轮机的轴与发电机转子相连结。
相关短句/例句
turbine rotor汽轮机转子
1.Nonlinear analysis of turbine rotor vibration faults;汽轮机转子振动故障非线性诊断研究
2.On-line calculation model of thermal stress of steam turbine rotor based on integrated modular modeling software;基于一体化模型软件的汽轮机转子热应力在线计算模型
3.Taking into consideration the four typical fault signals of turbine rotor vibration, including rubbing, loosening, misalignment and mass unbalance, collected from the Bently experiment set, the method combining wavelet packet and Kolmogorov entropy is introduced to carry out the classification and diagnosis.根据Bently实验台所采集的碰摩、松动、不对中、不平衡四种典型汽轮机转子振动故障信号,采用小波包和Kolmogorov熵相结合的方法对其进行故障诊断。
3)rotor of steam turbine汽轮机转子
1.It is proven that the rotor of steam turbine can be protected from permanent bending by means of cylinder holding.事实证明,闷缸措施可防止汽轮机转子永久性弯曲。
4)wheel disk(汽轮机)转子轮盘
5)turbo-rotor涡轮转子，汽轮机转子
6)turbine rotor涡轮机转轮，汽轮机转子，水轮机转轮
延伸阅读
汽轮机转子汽轮机转子steam turbine rotor 试脸是使转子在动平衡机上用加装平衡块的方法来达到动平衡，以保证转子运行的稳定性和可靠性。 大型再热汽轮机的转子一般由高压转子、中压转子和低压转子三部分组成，转子之间用联轴器连接，分别t于高、中、低压汽缸内(见汽轮机本体)。按结构机较少采用。 主轴是支持汽轮机转子在轴承中旋转的部件，或称大轴.主轴的概念来自套装转子。整锻转子和焊接转子的叶轮(或转鼓)和主轴则成一整体。 套装转子的主轴如图2所示。为了在主轴上套装箱要，有的将高、中压转子组合为一根，称作高中压联合转子。 汽轮机转子按结构分为套装转子、整锻转子和焊接转子三种基本型式(见图1)。有时也采用整锻一套装式或整锻一焊接式转子。 恋袭转子将叶轮和联轴器过盈装配于主轴上并用轴向或径向键传递转矩的转子。它一般用于中、低压转子，工作温度不大于400℃。对于受载较大的低压级叶轮，应采用端面径向键的结构型式.套装转子锻件尺寸较小，各零件可同时加工.制造周期短.工艺简单，造价低，但其零件加工、装配工作量大，转子刚性差，轮孔应力大，承载能力较低，运行灵活性差。现代汽轮 图2套装转子的主轴叶轮和联轴器等零件的方便，主轴做成阶梯形，中间直径最大，两侧的直径逐级减小，对应于各套装零件部位在轴上开有键槽。
