排汽缸,exhaust hood英语短句,例句大全

排汽缸,exhaust hood
1)exhaust hood排汽缸
1.However, most of the previous numerical simulations studied the exhaust hood separately without taking account of the effect of the inhomogeneous flow from the last stage.数值模拟一直是研究大功率汽轮机低压排汽缸内流场的主要方法之一。
2.As the computational domain includes exhaust hood and last two stages,it is difficult to obtain precise results using the single-block grid,so the multi-block mesh is adopted to get the detailed three-dimensional flow in exhaust hood.对于汽轮机低压排汽缸和末两级耦合的流场来说,单块网格难以保证计算的准确性。
3.Through the numerical study on the complicated 3-D flow field of steam turbine exhaust hood,the status and progress at home and abroad on the numerical study is reviewed in detail and expected to promote the study on numerical study and project application.通过对汽轮机排汽缸通道内三维复杂流动数值研究的分析和整理,综述了国内外排汽缸数值研究现状及进展,以期对此方面的研究及其工程应用起到促进作用。

英文短句/例句

1.a bank of cylinders in an engine发动机中的一排汽缸
2.engine cylinders radial arrangement发动机双排汽缸星形排列
3.engine cylinders opposed arrangement发动机双排汽缸相对平放
4.Aerodynamics and Heat Transfer Analyses of the Axial Exhaust Hood of the Combined Cycle Turbine;联合循环汽轮机轴向排汽缸气动及传热分析
5.Numerical Simulation on LP Exhaust Hood of 1000MW Ultra Supercritical Steam Turbines1000MW超超临界汽轮机低压排汽缸数值模拟
6.The Aerodynamic Optimization Design of Low Pressure Exhaust Hood for Steam Turbine Based on iSight Platform基于iSight平台的汽轮机低压排汽缸气动优化设计
7.Experimental and Numerical Investigation of Flow Field in Steam Turbine Low-Pressure Exhaust Hood with Air Cooling;空冷低压排汽缸内部流场的实验与数值研究
8.Research of Numerical Simulation of Flow Field and Calculation Method of Pressure Drop of Exhaust Hood排汽缸流场数值模拟及压损计算方法研究
9.pneumatic cylinder cock valve风动汽缸排水阀阀门
10.vertical tandem engine直立排列汽缸发动机
11.Probe into Modernization of Two-cylinder Two exhaust 100 MW Steam Turbine两缸两排汽100 MW汽轮机现代化改造
12.a radial engine辐射型引擎(汽缸排列成辐射状)
13.engine cylinders in line arrangement发动机汽缸直线单行排列
14.broad-arrow engine W形发动机(汽缸排成三列的发动机)
15.Clean the exhaust manifold and cylinder head mating surfaces.清洁排气歧管和汽缸头配合面。
16.Tighten exhaust manifold to cylinder head bolts.紧固排气岐管汽缸头螺栓。
17.Install cylinder head, intake manifold, and exhaust manifold, refer to cylinder head installation in this section.安装汽缸盖，进气歧管和排气管，请参阅本部分的汽缸盖安装。
18.Thermodynamic Analysis of the Last-stage Exhaust Steam Wetness of a Single-cylinder Low-parameter Steam Turbine单缸低参数汽轮机末级排汽湿度的热力分析